Material behaviour / 2026-11-20
Does puncture strength drop after aramid coating? Read the heat window first
A common worry is that adding a coating to the separator surface weakens it mechanically. This article reports the measured results for the ranges below 145 °C, 150 °C / 0.5 h and 180 °C / 0.5 h, and explains why the retention ratio and the absolute value have to be read separately.
The note
Figures are quoted with their test condition and standard; project-specific data is confirmed one to one at the sample stage.
What the test report says
The report states that after heat treatment at 145 °C / 1 h and 140 °C / 1 h the puncture strength of the coated separator is unchanged or slightly higher, and that temperatures below 145 °C do not reduce puncture strength. Within the ordinary heat treatment range, adding the coating layer does not cost mechanical strength overall.
At higher temperatures the conclusion becomes retention rather than invariance: in the 150 °C / 0.5 h window the double-side coated scheme retains 40-60% of its puncture strength, and in the 180 °C / 0.5 h window it still retains more than 20%. These are statements about a ratio, not about an absolute value, and the two are read differently.
Why retention and absolute value are not interchangeable
A retention ratio answers how much of the original capability survives the treatment; an absolute value answers how much there is now. One scheme can have the higher absolute value and the lower retention, and another the reverse. They serve different situations.
If the thermal risk of a cell comes mainly from a sustained extreme duty, retention is the more informative figure. If the concern is mechanical margin during assembly and normal cycling, the absolute value is more direct. State which part of the duty is being discussed before quoting either, otherwise the two cannot be compared.
What the temperature bands mean in engineering terms
Strength does not fall below 145 °C, retention becomes noticeably lower from 150 °C onwards, and more than 20% is still retained at 180 °C. Read together these describe a curve that decays with temperature, not a switch labelled high temperature resistant.
For cell design, the useful content of that curve is that safety margin should be assessed against continuous duty rather than against one nominal temperature point. Thermal shrinkage gives the corresponding conclusion on the dimensional side over the same range, and the two together describe high-temperature behaviour completely.
How to use these results at the sample stage
During sample validation it helps to list the metrics of concern by segment of duty: absolute value and air permeability for assembly and normal cycling; retention and thermal shrinkage for the expected high-temperature segment; peel strength for the interface. Each segment maps to its own test condition and standard, which makes it possible to report conclusions item by item.
At the sample stage the company provides test data and failure-analysis suggestions to narrow the parameter range, and keeps a technical contact window open during mass production to handle batch variation and failure analysis. The coating composition and process parameters are trade secrets and are not published; they can be provided in a one-to-one technical discussion.
Related pages
To discuss a parameter range for a specific cell architecture, contact the technical team directly.